how to install led retrofit kit in traditional shoebox

HOW TO INSATLL LED RETROFIT KIT IN TRADITIONAL SHOEBOX 

DANGER - READ ALL INSTRUCTIONS BEFORE INSTALLATION
 
OUR LED DEVICES MAY BE WIRED DIFFERENTLY THAN DEVICES FROM OTHER VENDORS. USE A LICENSED ELECTRICIAN TO PERFORM THE INSTALLATION!
 
1. For Longest Life & Heat Dissipation - PERMANENTLY REMOVE THE FIXTURE’S REFLECTOR. RETROFIT WARRANTY IS VOID IF THE FIXTURE'S REFLECTOR IS NOT REMOVED. UNDER NO CIRCUMSTANCES IS IT OK TO LEAVE THE REFLECTOR IN THE FIXTURE. REMOVING THE REFLECTOR PROVIDES EXTRA AIR CAPACITY THAT IS USED TO KEEP THE LED HEAD AND DRIVER COOL. 
 
2. Wipe excess dust from inside the fixture. 
 
led retrofit kit
 
3. Never take the led retrofit apart. Never touch the LEDs. THIS MAY VOID THE WARRANTY. 
 
led retrofit kit
 
TURN OFF ALL POWER TO THE FIXTURE!
 
4.Remove the bulb and existing ballast or cut the wires to the ballast and bypass it. 
 
led retrofit kit
 
CONFIRM THAT THE LINE VOLTAGE IS CORRECT FOR THE DRIVER!! 
 
5. BE SURE THAT NOTHING WILL TOUCH OR FALL INTO THE FAN BLADES AFTER THE FIXTURE IS MOUNTED. 
 
led retrofit kit
 
 
6. Install the LED driver in place of the ballast. You may customize the driver mounting plate by drilling holes so that it will mount into the fixture’s existing screw posts. 
 
led retrofit kit
 
7.The proper AC input connections to the driver are marked on the driver. There is a Ground, ACN (Neutral) and ACL (Line). 
led retrofit kit
 
 
8.Fix the whole elliptical bracket to the 4 fold-fins of LED retrofit kit by the screws.
 
led retrofit kit
 
 
9.Adjust the length of the 4 small brackets on the whole elliptical bracket or fold the brackets in half according to the size of the fixture.
 
led retrofit kits
 
10.Tighten the 4 small brackets to the fixture and adjust the final length of the brackets, then tighten the “butterfly” screws. 
 
led retrofit kits

led retrofit kits
 
11. Driver Output: Connect Red Wire to Red Wire and Black Wire to Black Wire of the LED light.
 
12. >>> REMOVE THE PLASTIC COVER FROM THE LED HEAD!! <<<
 
13. Re-assemble the remaining parts of the fixture and restore power.
 
14. When the light is on, the metal body will get hot. Do not touch.
 
15. Never dim a non-dimmable LED driver.
 
16. Not intended for use with emergency exits or emergency lights.